New Perforating Technique Improves Well Productivity and Operational Efficiency

Al-Marri Faisal, Hassan Ibrahim Khalil, Alan Salsman, Majed Shaaban Abu Lawi

Abu Dhabi International Petroleum Exhibition and Conference · 2006 · 10 citations · 14 references

Concepts

Abstract

Abstract A major challenge identified by ADMA OPCO is the time delay and subsequent lost production between a well being completed with the drilling rig until it is acid stimulated using a multi purpose barge and put on production. Some wells in ADMA OPCO fields that are perforated using conventional perforating techniques will not produce until stimulated with acid. A new perforating technique has been deployed that creates clean, low skin perforations and allows the well to be produced at commercial rates while waiting for the multipurpose barge and in some cases eliminate the need for stimulation. This new perforating technique utilizes a unique job design process and specific equipment to ensure the guns are detonated in the correct environment to create a dynamic underbalance* immediately after perforating. Laboratory tests show how this fast acting dynamic underbalance created across the perforated interval is used to clean perforation tunnels and produce low to zero damage perforation tunnels1–2. This paper describes how this new perforating technique was used in two ADMA OPCO wells to wireline perforate in multiple runs a carbonate reservoir which then produced more than 2500 bbl/day oil before acid stimulation. A fast acting memory recorder was run with the guns to record pressure transients in the well bore at the time of perforating. The subsequent acid matrix job on these wells further improved productivity. This paper will show the perforating strategy, execution requirements, post job monitoring and the final results. This is the first fully documented case of this perforating technique being used in a carbonate reservoir and the first time this technique has been used in Abu Dhabi.

References

14