Low-temperature plastic strain of ultrafine-grain aluminum

Y. Estrin, N. V. Isaev, T. V. Grigorova, V. V. Pustovalov, V. S. Fomenko, I. S. Braude, S.V. Malykhin, M.V. Reshetnyak, Miloš Janeček

Low Temperature Physics · 2008 · 20 citations · 20 references

Concepts

Abstract

The microstructure and mechanical properties of ultrafine-grain (UFG) commercial-grade Al obtained by equichannel angular pressing (ECAP) are study in the temperature range 4.2–295K. Transmission electron microscopy and x-ray diffraction methods are used to show that as the number of passes increases, the grain size decreases, the grain shape becomes increasingly equiaxial, and the dislocation density inside a grain and the character of the intergrain boundaries change. An increase of the coherent scattering region and a decrease of the level of microdeformations indicate that pressing decreases the total density of imperfections of the crystal structure inside grains. As temperature decreases, the yield stress, plasticity, and strain hardening rate of UFG and coarse-grain polycrystals increase substantially. The deformation of UFG polycrystals at 4.2K becomes unstable (abrupt). The temperature dependences of the yield stress σy(T) of UFG and coarse-grain polycrystals, where the form of these dependences is characteristic for thermally activated detachment of dislocations from short-range potential barriers, are studied. The differences observed in the dependences σy(T) for UFG polycrystals are explained by a change in the nature of such barriers and the mechanism by which glide dislocations overcome them. The dependences of the yield stress σy and the coefficient of strain hardening θ on the grain size d are obtained. It is determined that the Hall–Petch relation describes the function σy(d) in the temperature interval 4.2–295K. The Hall–Petch coefficient increases as temperature decreases. The function θ(d) is monotonically decreasing at 295 and 77K but θ is independent of d at 4.2K. The experimental data are discussed within the framework of existing notions about the influence of the microstructure produced by ECAP on the evolution of the dislocation density during subsequent deformation.

References

20