Microstructure and High‐Temperature Mechanical Behavior of Alumina/Alumina–Yttria‐Stabilized Tetragonal Zirconia Multilayer Composites

M. Jiménez–Melendo, C. Clauss, Arturo Doḿnguez‐Rodŕguez, Antonio Javier Sánchez‐Herencia, José S. Moya

Journal of the American Ceramic Society · 1997 · 29 citations · 27 references

Concepts

Abstract

Layered composites of alternate layers of pure Al 2 O 3 (thickness of 125 μ m) and 85 vol% Al 2 O 3 ‐15 vol% ZrO 2 that was stabilized with 3 mol% Y 2 O 3 (thickness of 400 μ m) were obtained by sequential slip casting and then fired at either 1550° or 1700°C. Constant‐strain‐rate tests were conducted on these materials in air at 1400°C at an initial strain rate of 2 × 10 ‐5 s ‐1 . The load axis was applied both parallel and perpendicular to the layer interfaces. Catastrophic failure occurred for the composite that was fired at 1700°C, because of the coalescence of cavities that had developed in grain boundaries of the Al 2 O 3 layers. In comparison, the composite that was fired at 1550°C demonstrated the ductility of the Al 2 O 3 +YTZP layer, but at a flow stress level that was determined by the Al 2 O 3 layer.

References

27