47th AIAA Aerospace Sciences Meeting including The New Horizons Forum and Aerospace Exposition · 2009 · 70 citations · 12 references
EngineeringAerospace EngineeringSystems EngineeringAircraft DesignAircraft StructuresDesign OptimizationAerodynamic DesignAircraft Configuration DesignAircraft PerformanceWeight EstimationWing AerodynamicsWing DesignAircraft Aerodynamic DesignAircraft Performance ModelingAircraft SizingBlended Wing Body DesignCompressibilityConceptual Aircraft DesignDragMission Definition
The objective of this study was to develop a hybrid wing body (HWB) sizing and analysis capability, apply that capability to estimate the fuel burn potential for an HWB concept, and identify associated technology requirements. An advanced tube with wings concept was also developed for comparison purposes. NASA s Flight Optimization System (FLOPS) conceptual aircraft sizing and synthesis software was modified to enable the sizing and analysis of HWB concepts. The noncircular pressurized centerbody of the HWB concept was modeled, and several options were created for defining the outboard wing sections. Weight and drag estimation routines were modified to accommodate the unique aspects of an HWB configuration. The resulting capability was then utilized to model a proprietary Boeing blended wing body (BWB) concept for comparison purposes. FLOPS predicted approximately a 15 percent greater drag, mainly caused by differences in compressibility drag estimation, and approximately a 5 percent greater takeoff gross weight, mainly caused by the additional fuel required, as compared with the Boeing data. Next, a 777-like reference vehicle was modeled in FLOPS and calibrated to published Boeing performance data; the same mission definition was used to size an HWB in FLOPS. Advanced airframe and propulsion technology assumptions were applied to the HWB to develop an estimate for potential fuel burn savings from such a concept. The same technology assumptions, where applicable, were then applied to an advanced tube-with-wings concept. The HWB concept had a 39 percent lower block fuel burn than the reference vehicle and a 12 percent lower block fuel burn than the advanced tube-with-wings configuration. However, this fuel burn advantage is partially derived from assuming the high-risk technology of embedded engines with boundary-layer-ingesting inlets. The HWB concept does have the potential for significantly reduced noise as a result of the shielding advantages that are inherent with an over-body engine installation.
12
Design of the Blended Wing Body Subsonic Transport
R. H. Liebeck · Journal of Aircraft · 2004 · 780 citations
Engineering, Aerospace Engineering, Mechanical Engineering +15
Airframe Design for "Silent Aircraft"
James Hileman, Z. S. Spakovszky, Mark Drela et al. · 45th AIAA Aerospace Sciences Meeting and Exhibit · 2007 · 117 citations
Engineering, Aerospace Engineering, Mechanical Engineering +17
Design of the Blended-Wing-Body subsonic transport
R. H. Liebeck · 2002 · 84 citations