Comparison of Assembly Tolerance Analysis by the Direct Linearization and Modified Monte Carlo Simulation Methods

Abstract

Abstract Two methods for performing statistical tolerance analysis of mechanical assemblies are compared: the Direct Linearization Method (DLM), and Monte Carlo simulation. A selection of 2-D and 3-D vector models of assemblies were analyzed, including problems with closed loop assembly constraints. Closed vector loops describe the small kinematic adjustments that occur at assembly time. Open loops describe critical clearances or other assembly features. The DLM uses linearized assembly constraints and matrix algebra to estimate the variations of the assembly or kinematic variables, and to predict assembly rejects. A modified Monte Carlo simulation, employing an iterative technique for closed loop assemblies, was applied to the same problem set. The results of the comparison show that the DLM is accurate if the tolerances are relatively small compared to the nominal dimensions of the components, and the assembly functions are not highly nonlinear. Sample size is shown to have great influence on the accuracy of Monte Carlo simulation.