Acousto-ultrasonics as a monitor of material anisotropy

Abstract

This paper discusses experimental results obtained by performing the acousto-ultrasonic (AU) method at various azimuthal angles on the surface of fiber-reinforced composite plates. The use of an IBM-PC/data-acquisition board to obtain a digitized AU signal to be analyzed by specially developed software is described. An introduction is given to the use of AU parameters to quantify information evidenced in amplitude/frequency plots. A description of how the parameters are obtained by calculating various spectral moments and the area under particular ranges of the spectral density curve is presented. Results are given from voltage/time plots, amplitude/frequency plots, and plots showing the variation of calculated AU parameters with azimuthal angle. Finally, how the variation of AU parameters with azimuthal angle may be related to variation in material properties with azimuthal angle is discussed.