Characterization of Illinois Aggregates for Subgrade Replacement and Subbase

Erol Tutumluer, Debakanta Mishra, Abbas A. Butt

Illinois Digital Environment for Access to Learning and Scholarship (University of Illinois at Urbana-Champaign) · 2009 · 38 citations · 0 references

Full text

Open access

Concepts

Abstract

Construction of a pavement working platform is often needed on soft, unstable soils to provide sufficient stability and
\nadequate immediate support for equipment mobility and paving operations without developing excessive rutting. The
\naggregate type and quality are important factors for determining the required treatment/ replacement thickness. The
\noverall objective in this project has been to characterize strength, stiffness, and deformation behavior of three crushed
\nand uncrushed aggregate materials, i.e., limestone, dolomite and uncrushed gravel, commonly used in Illinois for
\nsubgrade replacement and subbase. The goal has been to develop aggregate thickness correlations with aggregate
\nproperties to modify and improve the thickness requirement curve in IDOT’s Subgrade Stability Manual based on both
\nlaboratory and field performances.
\nThe initial laboratory phase of the study presented in this report considered both plastic and non-plastic fines (passing
\nNo. 200 sieve or 0.075 mm) blended in the engineered gradations of the limestone, dolomite and uncrushed gravel at
\n4%, 8%, 12%, and 16% target fines content. From the test results, the most important property at low fines contents
\n(less than 8%) was the aggregate type governed by the angularity, i.e. crushed or uncrushed, and the amount of
\nvoids in the aggregate matrix. Especially when plastic fines with a plasticity index or PI of 10 or higher were included,
\nthe amount of fines had a drastic effect on aggregate performance.