The Journal of Adhesion · 2015 · 31 citations · 24 references
Natural SciencesMaterials EngineeringMaterials ScienceMaterials CharacterizationMechanical Behavior Of MaterialsStructural MaterialsAdhesive BondingCrack AssessmentFracture MechanicsMechanical CharacterizationStrength Of MaterialsAdhesive Failure AnalysisAdhesive Failure ModesAdhesive Fracture MechanicsAdhesivesCrack Length MeasurementEpoxy AdhesivesFlexible SubstratesFracture Energy
ABSTRACTThe Mode I fracture energy of a polyurethane adhesive with low Young's modulus was investigated. Metal adherends in standardized double cantilever beam (DCB) tests are typically too stiff for soft adhesives, making it difficult to measure the fracture energy accurately. However, soft adhesives, such as a single-component polyurethane adhesive tested in this paper, are in high demand in the automobile industry. Thus, accurate measurement techniques must be established. Flexible substrates composed of spring steel were used for the DCB tests to accommodate the deformation of the adhesive layer. First, the applicability of the flexible substrates was discussed using specimens bonded with an epoxy adhesive. For soft adhesives, however, the deformation of the adhesive layer must be considered in the calculation methods of the fracture energy. Although the deformation effect on the DCB tests has been discussed with Winkler's elastic foundation, the crack length must be measured along with the load and displacement. To overcome the difficulty of measuring the crack length, a calculation method based on Winkler's elastic foundation was introduced applying the compliance-based beam method (CBBM). Finally, the fracture energy of the polyurethane adhesive was discussed by comparing the calculation methods with and without measuring the crack length.KEYWORDS: Automotivedouble cantilever beamfracture mechanicspolyurethanesoft adhesives AcknowledgementsThis paper is based on the results obtained from a future pioneering program commissioned by the New Energy and Industrial Technology Development Organization (NEDO). The authors would like to express their sincere appreciation to the project members who have provided valuable information and participated in useful discussions. They also wish to thank Sunstar Engineering Inc. (Japan) for material supply.
24